Is your system struggling, or is it the wrong fit for the house?
Before you plan a new system, there are a few things you can safely check yourself. Look at the furnace filter, because a clogged filter starves the indoor coil of air. Make sure nothing is blocking the outdoor unit, such as grass clippings, leaves or things stacked against it, and that the breaker and the outdoor disconnect are on. If the system runs but doesn't cool, or you see ice on the copper lines, turn it off at the thermostat and let the ice melt before you run it again. Those are repair problems, and air conditioner repair deals with them.
Other signs point to a problem with the installation itself. The upstairs bedrooms stay warmer than the main floor no matter how long the system runs. The air is cool but feels damp. The unit keeps switching on and off in short bursts. Some rooms were never connected to the ducts at all. These usually mean the equipment, the ductwork or both were never matched to the house, and putting in a new unit of the same size would give you the same result.
In Alcona's newer subdivisions, and in the newer parts of Lefroy and Belle Ewart, many houses still have the central air the builder put in with the furnace. When a whole street's systems went in at the same time, they tend to wear out at about the same time too, and neighbours often end up planning the same work within a summer or two of each other.
Can your ductwork carry central air?
Cooling usually needs more airflow than heating, and the cool air has to reach the top floor, where heat collects. Innisfil's oldest houses, in Big Bay Point, Stroud, Belle Ewart and Churchill, were built for wood or coal stoves and later switched to oil and then gas. Their ducts were usually added long after the house was built. Those ducts were sized for heat, often with few return-air openings, and they can be too small for central air.
Before we price a central system, we look at the supply and return ducts, the size of the main trunk and where the returns are. Sometimes all it takes is a larger return or a few rerouted runs. Sometimes the ducts can cool most of the house and a ductless unit handles the rest, such as a finished attic or an addition. We tell you which applies to your house and why.
What if the house has no ducts at all?
Most of the cottages along the Lake Simcoe shore have been converted into year-round homes. Houses like these, along with the older streets of Alcona and the modular homes in Sandy Cove, are often heated with electric baseboards or an oil furnace and have no ductwork. Many sit on a crawl space instead of a basement, which leaves little room to run new ducts.
For these homes a ductless system is usually the practical choice. An outdoor unit connects to one or more indoor units through a small hole in the wall, and the refrigerant lines and drain run in a slim covered channel. Nothing has to be cut through the floors. Most ductless units today are heat pumps, so the same equipment can also heat in spring and fall, and cold-climate models can handle more of the winter. If that interests you, read about heat pumps and ask which rebates are on offer right now before you decide.
How big should the air conditioner be?
Innisfil has a short cooling season, but it does get hot. At Environment Canada's Barrie WPCC station, the nearest station with climate normals, the average July daily high is 26.3 °C, there are 10.4 days a year above 30 °C, and the record high is 36.5 °C, set in August 2006 (1981-2010 normals). Most of the summer is warm rather than extreme, with a few stretches of real heat.
That affects sizing. An oversized unit cools the air fast and shuts off before it has removed much moisture, so the house ends up cool and clammy. An undersized unit runs flat out on the hottest days and still falls behind. We size the system to the house: its floor area, insulation, windows and which way they face, shade from trees, and what the ducts can carry. Matching the outdoor unit to the indoor coil and the furnace blower matters as much as the size of the unit.
How does an installation go?
It starts with a visit. We look at the house, the ducts or the places where ductless units would go, the electrical panel, and where the outdoor unit can sit with good airflow and away from bedroom windows. You then get a written price for the equipment and the work. Nothing is ordered or installed until you approve it.
On installation day, the refrigerant in the old equipment is recovered and the old unit is removed. The new outdoor unit goes on a level pad or a wall bracket, and the refrigerant lines are run, pressure-tested and evacuated before the system is charged. In Ontario, refrigeration and air conditioning is a compulsory trade. Work is performed by 313A refrigeration and air conditioning mechanics. With central air, the indoor coil usually sits on top of the gas furnace, and any work on a gas appliance has to meet the provincial gas code. Work is performed by TSSA-certified gas technicians.
When the installation is done, the condensate drain is run to a floor drain or a pump and tested, the thermostat is set up, and the system is run in cooling mode so you can feel the result. We show you where the filter goes, how to keep the outdoor unit clear, and what the manufacturer requires to keep its warranty valid, which usually means registering the equipment and having it serviced regularly. Furnace and AC maintenance covers the servicing.
When is the best time to plan it?
Spring and early fall are the easiest times. There is more room in the schedule, and you aren't waiting through a hot spell for the work. If your furnace is also near the end of its life, it can make sense to look at both together, because the coil, the blower and the controls work as one system. Furnace installation and replacement explains the heating side, and you can ask for a written price for either one or both.
