Skip to content
Furnaces, heat pumps and central air for Innisfil homes(249) 444-3411
Innisfil Heating Cooling

Furnace repair, all makes and models

Furnace repair in Innisfil

If the house is cold, start with the simple checks: thermostat set to heat, furnace switch on, filter not clogged, side-wall vents clear of snow. If the heat still does not come back, Innisfil Heating Cooling finds the fault on any make or model. You get a written price before the repair begins.

What to check first, what the fault is, and the price in writing before the fix.

Do you smell gas, or is the carbon monoxide alarm sounding?

If you smell gas or hear it hissing, leave the house first. Do not switch lights or appliances on or off, and do not try to find the leak yourself. Once you are outside, call 911, then your gas utility's emergency line. The utility makes the gas supply safe but does not repair furnaces. Once the leak has been dealt with, call us to find the cause and repair the appliance.

If a carbon monoxide alarm goes off, get everyone outside into fresh air. Call 911 if anyone has a headache, nausea or dizziness. Leave the furnace off until it has been checked. The Ontario Fire Code requires a working carbon monoxide alarm next to each sleeping area in any home with a fuel-burning appliance, a fireplace or an attached garage. If there is no alarm by the bedrooms, fit one before the next cold night.

The furnace fault we treat as most serious is a cracked heat exchanger. A crack can let combustion gases, including carbon monoxide, into the air the blower sends through the house. If we find one, we tell you plainly, show you where it is and recommend the furnace stays off until the problem is resolved. Then we go through the options with you.

Did the furnace stop after a snowfall or a cold snap?

This is the most common no-heat call in an Innisfil winter, and it is often the easiest to fix. Most houses on the newer streets of Alcona, Lefroy, Belle Ewart and Friday Harbour have high-efficiency condensing furnaces. These draw in air and push out exhaust through two plastic pipes in the side wall. When drifting snow covers those pipes, or frost builds up on the exhaust during a long cold spell, the furnace senses the blockage and shuts itself off as a safety measure, so nothing has broken.

Go outside and clear the snow from around both pipes by hand, without pushing anything into them. Then turn the furnace switch off, wait a minute and turn it back on. If the furnace lights and runs, keep the pipes clear for the rest of the storm. The Barrie WPCC station is the nearest Environment Canada climate station to Innisfil. It averages 223.0 cm of snow a year and 12.2 days colder than -20 °C (1981-2010 normals). Drifts and frost on these pipes are a normal part of winter here.

If the furnace still will not light, or the pipes keep icing up, the venting may need to be raised or rerouted. We can price that repair and do the work.

Why is the furnace blowing cold air or turning on and off?

First, make sure the thermostat is set to heat, the fan is set to auto rather than on, and the batteries are fresh. Then pull out the filter. A filter packed with dust starves the furnace of air. The heat exchanger overheats, a limit switch trips and the burners shut off while the blower keeps pushing cool air. A new filter often fixes the problem.

If the filter is clean, the usual causes are a short list. A flame sensor coated with residue cannot confirm that the flame is lit, so the furnace runs for a few seconds, shuts down, and repeats. A cracked hot-surface igniter will not light the burners at all. On a condensing furnace, a blocked or frozen condensate drain or a plugged trap trips the pressure switch, and the furnace stops with an error light. On many Alcona streets the builder installed the furnaces in the same few years, so neighbours often see the same parts fail one winter after another.

Short cycling can also come from a furnace that is too large for the house, or from ducts that are too small. In the older homes of Stroud, Churchill, Big Bay Point and Belle Ewart, the ductwork was often added long after the house was built for wood or coal stoves. It does not always carry the air a modern furnace needs. We check the ducts as well, because a new part will not cure a duct problem.

What do banging, squealing or rattling noises mean?

A loud bang when the burners light is usually delayed ignition. Gas builds up for a moment before it lights, often because the burners or the flame sensor are dirty. Have it looked at soon, because repeated bangs strain the heat exchanger. A squeal or a grinding hum usually points to the blower motor or the inducer motor, the small fan that pushes exhaust out the vent. As its bearings wear, it gets louder before it stops. A rattle can be a loose panel, which is harmless, or a loose part inside the blower, which needs attention.

Turn the furnace off if you hear metal grinding or smell burning, and leave it off until it has been checked. A faint dusty smell for the first few minutes of the season is normal. A smell that lingers, or a smell of hot wiring, is not.

In older homes with converted masonry chimneys, a fumy smell near the water heater can mean the chimney no longer draws properly after the furnace was moved to side-wall venting. A technician needs to look at this. Sometimes the fix is a chimney liner.

How does a furnace repair visit go?

Tell us what the furnace is doing, what you have already checked and what kind of house you have. The technician confirms the symptom with you, then tests the system: the ignition sequence, gas pressure, venting, condensate drain, safety switches and blower. You see what we found and hear it explained in plain terms.

Before any part is fitted, you get the repair price in writing and decide whether to go ahead. If the furnace is old and the fault is a big one, we give you a repair price and a replacement price side by side, and tell you which we would choose in your place. If replacement makes more sense, see furnace installation and replacement.

We repair furnaces of all makes and models. Work is performed by TSSA-certified gas technicians, as Ontario Regulation 212/01 requires for repairs to any gas appliance, and the work follows the CSA B149.1 installation code.

Can a tune-up prevent the next breakdown?

Several of the faults above give warning signs before they stop the furnace. These include a dirty flame sensor, a clogged condensate trap and a worn inducer bearing. A fall tune-up can catch many of them while the weather is still mild. See furnace and AC maintenance and our guide on whether a maintenance plan is worth it.

What we commit to

What can you count on when you call?

  • Licensed and insured

    Every technician holds a current TSSA gas technician certificate and is covered by liability insurance. Your home is protected on every job.

  • Every call is answered

    Day or night, a person or our receptionist answers, takes the details and a technician calls you back.

  • Written price before work starts

    You see the number and approve it before any part is fitted. No surprises on the invoice.

  • 1-year workmanship warranty

    All labour comes backed by a one-year warranty. If a repair we made fails within the warranty period, we return and fix it at no additional labour cost.

Questions about furnace repair

My furnace stopped after a snowfall in Innisfil. What can I check first?

Start outside. Most furnaces in Innisfil's newer homes, especially in Alcona and Lefroy, are condensing units that draw in air and exhaust through two plastic pipes in the side wall. If drifting snow or frost covers them, the furnace shuts itself off as a safety step. The Barrie WPCC station records an average of 223.0 cm of snow a year (1981-2010 normals), so this happens often here. Clear the pipe ends by hand, then turn the furnace switch off and back on. If it still will not start, book a furnace repair.

Where do I need carbon monoxide alarms in my Innisfil home?

The Ontario Fire Code requires a working carbon monoxide alarm next to each sleeping area in any home with a fuel-burning appliance, a fireplace or an attached garage. In Innisfil that covers most houses: gas furnaces in the Alcona subdivisions, converted heating systems in Stroud and Belle Ewart, and woodstoves in former cottages. If an alarm sounds, get everyone outside first and call 911 from there. Press the test button on each alarm today, and if the furnace has not been checked in a while, book a tune-up.

What should I do if I smell gas in my Innisfil home?

Leave the house first. Enbridge Gas, the distributor for Innisfil, says that if you hear or smell gas escaping you should go outside, call 911, and then call its emergency line. Do not switch lights or appliances on or off, and do not use a phone inside. Once the utility has made things safe, any repair to the furnace, water heater or stove itself is done by a heating contractor, because Enbridge does not repair appliances. When you are cleared to go back in, contact us about the appliance.

All questions

Is your heating or cooling doing something odd?

Tell us what you are seeing and hearing. We explain the likely cause and give you a written price before any work starts.